Search
No search results found
No search results found
Sea To Summit 25mm 2 Pin Side Release
Sea To Summit 25mm 2 Pin Side Release
See our entire range from Sea To Summit here!
The Sea To Summit 25mm 2 Pin Side Release is a repair buckle to replace a broken or worn out quick release buckle on, for example, a drybag or a backpack carrier belt. The two removable pins allow both parts of the buckle to be mounted in existing, sewn-on strap loops without the need to split the straps open and re-sew.
The buckle is designed for 25 millimeter wide straps, weighs approximately 14.5 grams and is installed with a standard Phillips screwdriver. It is a practical spare part to carry in your repair kit when hiking, camping and traveling.
The designation 2 Pin means that both the male and female parts of the buckle have a removable stainless steel pin. The design is suitable when the original buckle is in a sewn-in strap loop on both sides.
The pins are unscrewed, the buckle parts are placed in the respective strap eyelets and the screws are then refitted. This provides a durable repair without the need to change the existing seam.
This 2-Pin model is intended as a direct replacement for non-adjustable buckles. It is particularly suitable for roll closures on dry bags and some fixed buckles on backpack hip belts.
The buckle does not have a step lock and therefore cannot be used to adjust the length of the strap. If one side consists of a loose strap that needs to be tightened or released, Sea to Summit's 1-Pin Side Release model in the corresponding width is normally required.
The size specification 25 mm refers to the width of the strap or strap eyelet – not the total outer dimensions of the buckle. Measure the strap flat before ordering.
The buckle is not universal. Also check that the equipment has a fixed strap loop on both sides and that the buckle dimensions work with the existing design.
Repair buckle for 25 mm wide straps
Two removable pins
Fits fixed strap loops on both sides
Assembled without sewing
Requires only a Phillips screwdriver
Can be changed out on tour
Corrosion-resistant stainless steel pins
Durable POM buckle
Weighs only about 14.5 grams
Fits many drybags and some backpack straps
Provides a durable replacement for a broken quick release buckle
Practical to carry in the repair kit
Product type: Side opening repair buckle
Strap width: 25 mm
Number of pins: 2
Adjustable: No
Buckle material: 100% POM
Material, pin: 100% stainless steel
Dimensions: Approximately 3.6 × 1.1 × 5.3 cm
Weight: Approximately 14.5g
Color: Black
Tools for assembly: Phillips screwdriver
Common uses: Drybags and some fixed buckles on backpack hip belts
Quantity in the package: 1 complete buckle
Remove the broken buckle without damaging the strap loops or stitching. Unscrew the stainless steel pins from both parts of the new buckle with a Phillips screwdriver.
Place each buckle part into the existing strap eyelet, replace the pins and tighten the screws securely. Do not tighten more than necessary. Then check that the buckle opens and closes correctly and that both pins are securely in place.
Check the straps and stitching at the same time. A new buckle will not fix a damaged strap or a stitching that is coming loose.
The buckle is intended for repair of compatible outdoor equipment and is not certified for climbing, personal belaying, or other uses where a failure could cause a fall or serious personal injury.
Rinse the buckle in clean water if it has been exposed to sand, dirt or salt water. Let it dry and check regularly that the pins are tight and that the plastic is not cracked.
